Lift cylinder #60 hough

[Timothy562020]

Need to fix the lift cylinder on the #60  hough.  How does the center pin come out?  I took the outside cover off expecting to find a threaded hole in the pin to turn a bolt in and pull the pin no such luck.  Took the grease fitting out on the inside and stuck a small bolt in the hole but can not push it out by hand.

[Timothy562020]

Never mind I was trying to take a piece off that didn't need to be taken off . Got it off and Dakota fluid power in Mandan ND repaired it for $850.

[Rawleigh99]

Good job!  Got any pictures?

[Timothy562020]

13 hours ago, Rawleigh99 said:

Good job!  Got any pictures?

Sorry I haven't figured out how to do that yet. But it is a 1968  #60 , it also has a factory third valve  and a  V6 cummins  352.  Hardest starting engine I have ever seen 85 degrees and it needs a shot of starting fluid for the first start of the day.  It is just a back up now.  Few years ago when using it to feed cows in winter it sat in an unheated barn routine was to plug in a 1000 watt tank heater when done with feeding then if -10 or colder a warm can of starting fluid and use the hair dyer to blow hot air into the intake for a couple of minutes.