Jump to content

820 head cutter bar stuck


BobinIL

Recommended Posts

Check your float springs on the back where the tubes are inside the springs. The tubes can get dust in them and the rod that runs in there packs it down and limits travel. It's item 10,11,12 on cnh parts site. Sadly no part numbers. 

Link to comment
Share on other sites

On 10/19/2020 at 7:40 PM, kal said:

Check your float springs on the back where the tubes are inside the springs. The tubes can get dust in them and the rod that runs in there packs it down and limits travel. It's item 10,11,12 on cnh parts site. Sadly no part numbers. 

The exact same issue we had on our 15' 820 header. Cleaned them up, head ran level.

Link to comment
Share on other sites

On 10/19/2020 at 7:40 PM, kal said:

Check your float springs on the back where the tubes are inside the springs. The tubes can get dust in them and the rod that runs in there packs it down and limits travel. It's item 10,11,12 on cnh parts site. Sadly no part numbers. 

Ditto

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...