Jump to content

Search the Community

Showing results for tags 'spindle assembly'.

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • Boards
    • Technical IH Talk
    • General Chat
    • Projects, Builds, & Restorations
    • Support
    • Announcements
    • IH Construction Equipment
    • IH Trucks
    • IH Engines
    • Cub Cadets
    • IH Toys, Memorabilia & Collectibles
  • Archives
    • Archived Posts

Find results in...

Find results that contain...


Date Created

  • Start

    End


Last Updated

  • Start

    End


Filter by number of...

Joined

  • Start

    End


Group


AIM


MSN


Website URL


ICQ


Yahoo


Jabber


Skype


Location


Interests

Found 1 result

  1. I have a 1968 IH 544 Gas. The front left steering arm and spindle nut were welded together but the weld cracked. Rather than just adding more weld (or creating a V and filling) I wanted to see what parts it needed & replace them. Pretty sure I have a frankenstein here and should probably just replace the spindle/nut/washers/felt gasket/steering arm to get back to 'factory' but wanted to check with the forum to make sure I wasn't missing something. Starting shape: Ground down the weld then undid the nut (or tried to) and sheared off some of the top of the shaft. Now I'm not certain what this shaft is for & what was done to it. Looking online all the replacement shafts listed have fine splines on them...not the course ones shown above. I'm half wondering if someone put a longer spindle on and welded the larger splines from another tractors steering arm on to the top of my steering arm? Bad Side (left) vs Good Side (right) I can tell things aren't quite the same. The nut/shaft size even differ. Nut comparison
×
×
  • Create New...