Jump to content

Search the Community

Showing results for tags 'pins are too tight'.

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


  • Boards
    • General IH
    • Coffee Shop
    • Projects, Builds, & Restorations
    • Support
    • Announcements
    • IH Construction Equipment
    • IH Trucks
    • IH Engines
    • Cub Cadets
    • IH Toys, Memorabilia & Collectibles
  • Archives
    • Archived Posts

Find results in...

Find results that contain...

Date Created

  • Start


Last Updated

  • Start


Filter by number of...


  • Start





Website URL







Found 1 result

  1. Thanks to a forum meeting I got a line on a skid steer adapters for my older 1984 Kubota L275. It was delivered last week and I went to mount it yesterday. From all the things I heard, getting the old pins out of the bucket was going to be the worst part of the job. After getting out the coffee pins the loader pins popped out very easily. Lined up the adapter put in the lower pins without an issue and that is when the fun started! The new pins I got from Kubota are just a hair too big to fit into the holes on the end of the cylinders for the bucket curl arms. I got them in about an inch, but that was it. I stopped beating on them before I beat up the ends of the pins, or damaged the cylinders or the adapter. Any ideas ? I tried polishing them down a bit with my little belt sander, but that didn't seem to help. I might run them around on the grinding wheel, but thought I would try here for ideas first. I guess I could take the dremel to the inside of the cylinder ends. Give me your thoughts. The pins are the factory recommended ones for the ssqa application. Thanks!
  • Create New...