Search the Community

Showing results for tags 'ih 3588'.

More search options

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


  • Boards
    • General IH
    • Coffee Shop
    • Projects, Builds, & Restorations
    • Support
    • Announcements
    • IH Construction Equipment
    • IH Trucks
    • IH Engines
    • Cub Cadets
    • IH Toys, Memorabilia & Collectibles
  • Archives
    • Archived Posts

Find results in...

Find results that contain...

Date Created

  • Start


Last Updated

  • Start


Filter by number of...


  • Start





Website URL







Found 3 results

  1. Patrik

    Pivot point play

    Hello I noticed today when discing a uneven field that our 3588 has a bit of play in one or both pivot bearings, about 1-2 cm (2/5"-4/5"). They have been replaced once before so it's a bit strange that it is needed agian. What is a good way to check the play in the workshop?
  2. Patrik

    Quick question

    How much work would it be to change the o-rings/seals in the lift cylinder? We suspect it's leaking because the hitch only goes half way and won't pick up if you load it.
  3. Patrik

    I'm at a loss

    As the title dictates I'm at a loss with our 3588, it sticks in 1st gear when the tractor is on in high, low or reverse. When in neutral or park it comes out, not "smooth" a tad bit rough. When the tractor is shut off it comes out the sameway in low, high, reverse, neutral or park. I have the TA, clutch and dump valve setup according to Farmall Doctor instructions, the transmission brake was assembled backwards with the lever pointing towards the front tire by the previus owner so that doesn't work. I'm thinking if the two balljoints are not parrallel, if that could cause the issue but then how did it work when brand new? I have no idea what the problem is, please help!