Jump to content

Vanstractors

Members
  • Posts

    362
  • Joined

  • Last visited

Everything posted by Vanstractors

  1. Very Nice ! Looks Great, Glad to see the old girls being taken care of !!
  2. Devon,s has done a few for me total rebuilt decals and all
  3. Hopefully someone has good advice im starting same thing on a 1566 watching closely !!!
  4. Success ,Finally took awhile but pressure washer, heat,kroil oil ,constant pull ,large hammer ,several bad words ,and lots of determination got em !Now get them off tractor (1566)to replace bushings and seals !
  5. Getting started new bushings bearings ends usual wear items on 66 front ends .Got get mobile to get pressure washed and into heated shop !!!Too old for unheated shop anymore !
  6. Starting new project have some stiff steering would like to replace mcv pump and new springs etc what and who,s kit do you like ?Thank You !!!
  7. Starting new project have some stiff steering would like to replace mcv pump and new springs etc what and who,s kit do you like ?Thank You !!!
  8. Wasn,t planning on it .Already have a canopy from Ed Leaman .It,s pretty rough cosmeticly. Nothing electrical works !Mechanically power steering is sluggish and stiff ?Showing right at 4000 hrs drawbar looks good .Havent fooled with it very much .Need rear rims for sure though .Have a 14 with a nice cab !Cold ac good radio ! It,s staying on.Thanks All for the nice comments!!!!!
  9. Thank You to all on this forum that helped along the way!!!On to 1566 next Join the 7 and 10
  10. Still have a couple grease zerks to change but basically done !!
  11. Looking for good gauge set for this 966 what your thoughts ? Hate to do the India route but what else ?Rochester somewhere ? Thanks
  12. Thanks to all ! Lot more fun to put back together !
  13. Went the a and I route part #A-50291005- A-50291007 It needed it all including spindles Tractor had not seen a grease gun in years .
  14. 966 Blackstripe Rods and Mains front and rear main seal clutch flywheel and TA All new frontend .Motivated to start going back together !
  15. I have an IH 110 silage box good working condition if you have a need still .Box only using the gear .

    1215171607.jpg

    1215171607a.jpg

  16. Has been a little bit but Brillman used to have them .I have several sets from him .I would call him and make sure .
  17. Might try Steve Smith in Republic Ohio .I have his number just have to find it .
  18. Thank You ! And Thanks to this forum for all the help .
  19. Finally got sheet metal on .Still have to get clutch adjusted and a few odd and ends but can at least get it out of the shop !
×
×
  • Create New...