Ihi driver

Hi Have to ask about frontaxle here, there its a 833 with zf APL 1251, does the zf APl 1351 fit to that Tracktor , much of parts fit together like axle shaft , swingparts

Oppdater om dette arbeidet, rengjør sylinderhodet, ventiler, bytt ventilpakninger, overflate og topp, og sylinderblokk og dens montert sammen , Kjør motoren varm , høyre sylinderhodebolter, mistet en bolt en Bye one, og strammet til 142 Nm , byttet ventilaksel og strammet mutrene på 110 Nm og justerte ventilene på 0,30 , og motoren fungerer fint , trenger også mindre glød, Deler et bilde av den dårlige pakningen Jeg tar en video av traktorkjøring, men kan ikke dele noe om filtype, den har ikke tilgang her

thank you so very much you mailed me , to day i go to feet to gether the cylinderhaed and the the rest of the parts 👌

The Tractor its ihi 633, APL 1251 was fited om 533,633, and APL 1351 was fited om 733 and 833

HI its some here its now the Torque of the hub nut fore Frontbearing of this frontaxle

that manuale tel nothing about to replement or not of cylinder headbolts , not easy to find good anwer of that

How much Torque need the hub of frontwheel bearing have ,there its APL1251 Axle

How much torque step by step of the heabotls its there torque of the bolts after the enginge have been varm

There was no information of headbotlts there.., the closed i com was the head

Dette er ikke en ve høytrykkspumpe, men en høytrykkspumpe av typen va, som bildet her

Of 633 pumpe its the upper relage the gas and the lower relage the stop of engine funktion .

This 633 from 1977 have Bosch pumpe. And i lift litle on the handgas fore the coldstart , the injektorer its overall og new needle and the prestere Are adjusted Litle of opening og from 225 bar too 205 bar because the pumpe can't made this same presure over long time

Hi, its D179 germany made engine or English and bolts sizeog inch og noth metric size

Hi try too fine out some History abut 633/179 , its The Tracktor , engine, made in germany like some say or GB ?