Jump to content

Big Steve

  • Posts

  • Joined

  • Last visited

Posts posted by Big Steve

  1. I think low 4 is too high in our area 10500 farm stock class your stock 806 is going to be under powered by30 to70 hp I think 3rd would be better. Stock is a pretty loose word. They just look stock lol

    • Like 1
    • Thanks 1
  2. 40 by 60 16 sidewalls 2inchs close cell foam on sidewalls 3inch at rafters and above new in 2018. Heated with 80,000 furnace cooled with 3.5 ton central a.c. keep it at 65 in winter and 75 in summer only time doors are open Is to move stuff in or out. It raised my electric  bill 40 dollars a month  in the summer and use less than 800gal l.p. in the winter.  Were located central Illinois.  Was in the shop all day  if I didn't have a.c. would have seating in the house not working in the shop


  3. You can get 6 different wheel setting with the rims in the picture if not more. 1 center dish in 2. Center dish out 3. Rim bracket inside center.  4. Rim bracket outside center. 5. Rim switch to other side bracket outside center. 6. Rim switch to other side bracket inside center. 

  4. Your 7120 will run the planterjust fine if you set your flow control properly. Put a pressure gauge in the motor supply line  you have to keep the pressure under 2000 psi or you will lock the flow out of the pump where you have it set at . I have set a lot  of  Deere planters on Magum tractors when I  worked at the dealership send me a PM if you more information. 

  5. If  memory serves me right the first and maybe the  second  407 blocks didn't have  enough water jacket  on the right side to cool a turbocharged  tractor it would  crack the sleeve. This happened on the 1256  you can tell the early blocks on the right side it followed the curve of the  sleeve. The later blocks were smooth on the right side and I thought they used those blocks up on the 856.

  6. Reverse is half the speed of forward . The springs on the hydro are getting weak  the load can overpower the spring and return the shach plate back to neutral .The hydro linkage should be rebuilt  but  you can put a 1/4bolt n the reverse slot so you can over ride the load with the hydro  lever.

  • Create New...