282 head gasket
Posted 20 February 2012 - 02:12 PM
Always love the forums!
Posted 20 February 2012 - 03:49 PM
IH 1066 Hydro's (2)
Farmall 1206 Diesel
Farmall 806 Diesel
IH 756 Gas
Farmall Super C
Hough H-60 Payloader
Cat D4D Dozer
Case 680E Backhoe
Hein-Werner C14A Excavator
"Personally I''m always ready to learn, although I do not always like being taught."
"Well, I'd like to help, but not as much as I'd like not to."
"I am a very smart man, don't you think I would know if I were wrong?"
"Success is the ability to go from one failure to another with no loss of enthusiasm"
"For unto whomsoever much is given, of him shall be much required"
"Speaking for God, is the greatest of all sins"
"The only thing necessary for the triumph of evil is for good men to do nothing"
"It is better to conquer yourself than to win a thousand battles. Then the victory is yours. It cannot be taken from you, not by angels or by demons, heaven or he11"
"There is nothing wrong with me, that a complete personality change could not fix"
"It is foolish and wrong to mourn the men who died. Rather we should thank God that such men lived."
General George S. Patton, Jr.
Posted 29 February 2012 - 10:31 PM
Should I have the head gone through if I remove it even though it's runnin good? If so what would a cost figure be so I can compare.
Last head I did ran around 550 US. It was pretty tired, but ought to be good for another few decades now. Tanked, crack checked, surfaced, all new vales, seats, guides, springs. Since the head will be off, take it to a good machine shop to clean and crack check carefully. 282D heads are known for cracking, so invest just a little to get an opinion, before committing any work.
Posted 01 March 2012 - 09:18 PM